Skip to content
LawrenceHeights Locksmith ServicesOpen 24/7 (289) 236-8131
Person holding a black door-handle assembly and a latch beside a glazed door with exposed lock openings. — Smart Lock Installation, Armour Heights

Change or rekey · Armour Heights

Smart Lock Installation

You have just taken possession of the house and the previous owners handed over a keypad deadbolt with a code nobody wrote down and an app account you cannot get into. It needs to become yours, properly, or be replaced.

In plain words

A smart lock fitted by a locksmith keeps a way in that works when the battery or network fails, a mechanical key on many models or an external battery contact on key-free ones. Most keypad deadbolts keep a conventional keyway, rekeyed during the visit so a fresh key operates it and the old one retires. Some models instead add small outside terminals where a nine-volt battery can wake a dead lock long enough to enter a code. The technician tests whichever route the model provides, shows the low-battery warning, and explains what the lock does if the internet goes quiet.

Sound familiar?Armour Heights

The call
You have just taken possession of the house and the previous owners handed over a keypad deadbolt with a code nobody wrote down and an app account you cannot get into. It needs to become yours, properly, or be replaced.

NextHow the visit goes

Smart Lock Installation · Armour Heights

How the visit goes

Technician kneeling with a yellow cordless drill at the latch plate of a black door, a tool bag on the porch. — Armour Heights
  1. Scene 1

    Measuring the door and its holes

    Smart locks are built around the standard residential preparation, so the locksmith measures before choosing. Door thickness is usually between 35 and 45 millimetres; thicker doors need an extension kit and very thin ones may need a different model. The large cross bore for the cylinder, the smaller edge bore for the bolt and the backset from the door edge to the centre of the hole are each checked against the new lock's range. A lever set also needs the handing confirmed. Steel and fibreglass doors, doors with a mortise pocket from an older lock, and doors with glass close to the handle each change what will fit and how it is mounted.

  2. Scene 2

    Power up and teach the lock its door

    Once the hardware is tight, the lock gets the batteries its maker specifies, all fresh and all the same type, since mixing old and new cells shortens the life of the set. Most models then run a short calibration in which the motor learns which way is locked, how far the bolt travels and where it meets resistance. The locksmith runs this exactly as that model's instructions direct, door open or closed depending on the maker, then cycles it several times from the keypad and the thumb-turn while listening for a motor that strains. If the lock has a door-position sensor or a magnet to fit on the frame, it is placed and confirmed at this stage.

  3. Scene 3

    A written record without your secrets in it

    The visit closes with a plain note of what was done: the model fitted, the door corrections made, whether the strike was reinforced, which override cylinder was rekeyed and how many keys were cut, and which other doors were brought onto the same key. What the note never contains is a code, a password or a login; those exist only on your account and in your head. For a tenant, that record is the thing to share with a landlord so both sides know what hardware is on the door and that a working way in exists. For an owner, it simply goes in the folder with the house documents.

In the van

  • Thick-door extension kit
  • Hole saw, spade bit and drilling jig
  • Door-position sensor magnet
  • Wi-Fi bridge or home hub
  • Hand screwdrivers, Phillips and Torx

What shapes the quoteLawrence Heights Locksmith Services

Finish and matching hardware
Standard finishes are the base. A less common finish, or replacing the knob or lever at the same time so the door matches, adds to the hardware portion of the quote.
Rekeying the override cylinder and other locks
Repinning the smart lock's backup cylinder to a new key, cutting the keys and bringing the remaining mechanical locks onto the same key are each counted per cylinder and per key.
Supplying the lock yourself
If you have already bought a lock, the quote covers fitting and setup only, with a note on whether the chosen model suits your door; if the locksmith supplies it, the hardware is listed alongside.

FeesSame any hour

Have it ready

Before you call · 0 / 3

(289) 236-8131

Straight answers

Can the back door and garage door be put on the same system?

Yes, in one of two ways. Each door can get its own smart lock, all managed from the same app and account, with the same codes working at every door. Or, where the cylinders share a compatible keyway, the other doors can stay mechanical and be rekeyed so a single key operates them and the smart lock's override cylinder alike. Many households do the front door first and add the others later; the account and the codes carry across.

Will a smart lock fit my existing door?

Most residential doors have the standard preparation these locks are designed around: a large hole for the lock body, a smaller one in the edge for the bolt, and a thickness between roughly 35 and 45 millimetres. The locksmith measures all three plus the backset before recommending a model. Thicker doors take an extension kit, thin or glass-panelled doors and older doors with a mortise pocket call for a particular model or some preparation, and all of that is sorted out before the box is opened.

Do I still get a key?

In most cases, yes. The majority of keypad deadbolts keep a conventional cylinder behind or beside the keypad, and the locksmith rekeys it during the visit so a fresh key works and the old one is retired. A few designs have no keyway at all and rely on the keypad plus an emergency power contact instead. Which you prefer is part of choosing the model, and either way the fallback route is tested before the locksmith leaves.

Armour Heightsinformation

TorontoOntario

Town
Armour Heights, Toronto
In business
14 years
Hours
Open 24/7
Nights, weekends and holidays, same fees
Visits
On-site assessment preferred. Request a visit or call.

2021 census: what it means at the door

Every square is one home in a hundred.

  • 58 in 100 homes · older homes
  • About 58% of homes in Toronto were built in 1980 or earlier, according to the 2021 Census.Basement and side entries on older homes were often fitted long after the house was built, with whatever lock was on hand. Bringing those doors up to the standard of the front entry, and onto the same key, is a common and satisfying job.
  • Single-detached houses make up about 23% of homes in Toronto (2021 Census).Landlords and property managers dominate in attached housing, and they want keys organised. A locksmith sets up master systems so a manager carries one key while each tenant's key opens only their own door.

Source: Statistics Canada, Census Profile

Open Armour Heights in Google Maps

On-site assessment

Request a visit.

You have just taken possession of the house and the previous owners handed over a keypad deadbolt with a code nobody wrote down and an app account you cannot get into.

(289) 236-8131, open 24/7.